’08 Rav4_U (L/O 0802)
102
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
TO USE THE OUTSIDE ANCHOR
BRACKET:
1. Remove the head restraint.
Hold the center of the lever and pull it
up. Then slide the rear/second seats
forward slightly if it is in the rear−most
position.
2. Fix the child restraint system with
the seat belt.
Widen the slit of the cover slightly
and confirm the position of the an-
chor fitting. Latch the hook onto the
anchor bracket and tighten the top
strap.
For instructions to install the child re-
straint system, see “Child restraint” on
page 85 in this Section.
To Next Page
Loading...
