403
2008 TUNDRA from Apr. ’08 Prod. (OM34477U)
Operate the accessory meter with the
engine switch on.
When the engine switch is turned to “ON”,
the last previously used mode displayed
just before the engine switch is turned off
will appear.
When the instrument panel lights are
turned on, the brightness of the display
will be reduced.
CAUTION
Do not adjust the display while the
vehicle is moving. Be sure to adjust
the display only when the vehicle is
stopped.
SELECTING UNIT
You can select the unit between En-
glish/U.S. customary system and metric
unit.
Vehicles without multi−information dis-
play—
To select unit A (English/U.S. customary
system) or unit B (metric unit), push the
“SETUP US/M” button.
The unit variations are as follows:
Information
Unit A Unit B
Average fuel
consumption and
Instantaneous
fuel consumption
MPG L/100 km
Driving range MILES km
Outside
temperature
!F !C
Vehicles with multi−information display—
By changing the multi−information display
unit, the outside temperature display on
the accessory meter will change. (See
“Multi−information display” on page 187 in
Section 1−6 for selecting unit.)
XS10003b
The displayed temperature ranges from
−40!F (−40!C) up to 122!F (50!C).
The engine switch must be in the “ON”
position.
If an abnormality exists in the connection
of the outside air temperature sensor,
“−−−!F” (“−−−!C”) will appear on the dis-
play. If “−−−!F” (“−−−!C”) appears on the
display, contact your Toyota dealer.
There may be a case that “−−−!F”
(“−−−!C”) appears momentarily when the
engine switch is quickly turned to “ON”.
It is normal if it goes out soon.
07 11.20
—Before using the accessory
meter
—Outside temperature display
(without cruise information)
To Next Page
Loading...
