338
5-4. Other interior features
4RUNNER (U)_(OM35A83U)
■
Circling calibration
If “” appears on the left side of
the direction display, circling
calibration needs to be per-
formed.
Stop the vehicle in a place where it is safe to drive in a circle.
In deviation calibration mode
(P. 337), press and hold
the “MODE/ ” button to
change to circling calibration
mode.
“” on the left side of the direc-
tion display will blink.
Drive the vehicle in a circle
completing at least one full
circle within 20 - 120 sec-
onds.
If there is not enough space to
drive in a circle, drive around the
block until a direction is dis-
played.
Press and hold the “SET/ ” button to confirm the direction and
to exit circling calibration mode. (If the button is pressed for sev-
eral minutes, the direction will automatically be confirmed and
the display returned to normal.)
Make sure that “” on the left side of the direction display has
gone off. If “” is illuminated, perform the above procedure again.
1
2
3
4
5
To Next Page
Loading...
