59
To turn on the windshield wipers,
move the lever to the desired setting.
The key must be in the “ON” position.
Lever position Speed setting
Position 1 Intermittent
Position 2 Slow
Position 3 Fast
The “INT TIME” band lets you adjust the
wiping time interval when the wiper lever
is in the intermittent position (position 1).
Twist the band upward to increase the
time between sweeps, and downward to
decrease it.
To squirt washer fluid, pull the lever to-
ward you and release it.
If the windshield wipers are off, they will
operate a couple of times after the washer
squirts.
For instructions on adding washer fluid,
see “Adding washer fluid” in Chapter 7-3.
In freezing weather, warm the windshield
with the defroster before using the wash-
er. This will help prevent the washer fluid
from freezing on your windshield, which
can block your vision.
NOTICE
Do not operate the wipers if the
windshield is dry. It may scratch the
glass.
To turn on the windshield wipers,
move the lever to the desired setting.
The key must be in the “ON” position.
Lever position Speed setting
Position 1 Slow
Position 2 Fast
For a single sweep of the windshield, push
the lever up and release it.
To squirt washer fluid, push the button
at the end of the lever.
For instructions on adding washer fluid,
see “Adding washer fluid” in Chapter 7-3.
Windshield wipers and
washer (intermittent type)
Wind shield wipers and
washer (mist type)
To Next Page