86
The rear differential lock system is
provided for use only when wheel
spinning occurs in a ditch or on a slip-
pery or ragged surface.
This differential lock system is effective in
case one of the rear wheels is spinning.
Before using the rear differential lock sys-
tem, first shift the front drive control into
“L4” with the free-wheeling hubs engaged
to see if it works. If this has no effect, addi-
tionally use the rear differential lock sys-
tem.
Do not use the rear differential lock
in the conditions other than above.
Large steering effort and careful
cornering control will be required.
CAUTION
!
To lock the rear differential, push the
switch.
Be sure to stop the wheels before locking
the differential.
Vehicles with manual transmission—For
easy locking, depress the clutch pedal,
push the lock switch and slowly release
the clutch pedal.
The indicator light will blink when the
switch is turned on. Wait a few seconds for
the system to complete operation. After
the differential is locked, the light will stop
blinking and remain on.
Rear differential lock system
To Next Page