85
With A.D.D.
To shift from “H2” to “H4”, reduce your
speed to less than 80 km/h (50 mph) and
move the front drive control lever.
If you have trouble shifting in cold weath-
er, reduce your speed or stop the vehicle
and reshift.
Never move the front drive control
lever if wheels are slipping. Stop the
slipping or spinning before shifting.
CAUTION
!
To shift from “H4” to “H2”, simply move
the front drive control lever. Also, disen-
gage both the free-wheeling hubs for con-
tinued “H2” use.
This can be done at any vehicle speed.
If the indicator light does not go off when
you shift the transfer into “H2”, drive
straight ahead while accelerating or de-
celerating, or drive in reverse.
SHIFTING BETWEEN “H4” AND “L4”
To shift between “H4” and “L4”, stop
the vehicle and put the transmission in
“N”. With your foot holding down the brake
pedal, move the front drive control lever.
SHIFTING BETWEEN “H2” AND “H4”
To shift from “H2” to “H4”, reduce your
speed to less than 100 km/h (62 mph) and
push in the “4WD” button. You need not
depress the clutch pedal.
If the indicator light does not come on
when you push in the “4WD” button, drive
straight ahead while accelerating or de-
celerating.
If the indicator light flashes and the buzzer
sounds when you push in the “4WD” but-
ton, reduce your speed or stop the vehicle
and reset.
Never push the “4WD” button if
wheels are slipping. Stop the
slipping or spinning before shifting.
CAUTION
!
To shift from “H4” to “H2”, push the
“4WD” button aging to turn it off.
This can be done at any vehicle speed.
You need not depress the clutch pedal.
If the indicator light does not go off when
you shift the transfer into “H2”, drive
straight ahead while accelerating or de-
celerating, or drive in reverse.
SHIFTING BETWEEN “H2” OR “H4”
AND “L4”
To shift from “H2” or “H4” to “L4”, stop
the vehicle or reduce your speed to less
than 8 km/h (5 mph). With your foot off the
accelerator pedal, depress the clutch
pedal and move the front drive control le-
ver.
To shift from “L4” to “H2” or “H4”, de-
press the clutch pedal and move the front
drive control lever. When the “4WD” but-
ton is pushed in, the transfer shifts into
“H4”; when the button is left out, the trans-
fer shifts into “H2”
This can be done at any vehicle speed.
If the indicator light does not go off when
you shift the transfer into “H2”, drive
straight ahead while accelerating or de-
celerating, or drive in reverse.
(c) Shifting procedure
(lever/button type)
To Next Page