348
3-6. Other interior features
4RUNNER_U_(L/O_0808)
Te st the op e ra tio n o f th e Ho meL in k
®
by pressing the newly
programmed button. Check to see if the gate/device operates
correctly.
Repeat the steps above to program another device for each of
the remaining HomeLink
®
buttons.
n Programming other devices
To p rog ram o the r de vic es suc h as home security systems, home
door locks or lighting, contact your authorized Toyota dealer for
assistance.
n Reprogramming a button
The individual HomeLink
®
buttons cannot be erased but can be
reprogrammed. To reprogram a button, follow the programming
instructions.
Operating the HomeLink
®
Press the appropriate HomeLink
®
button. The HomeLink
®
indicator
on the HomeLink
®
transceiver should turn on.
The HomeLink
®
continues to send a signal for a maximum of 20 seconds
if the button is held in.
Erasing the entire HomeLink
®
memory (all three programs)
Press and hold down the 2 out-
side buttons for 20 seconds until
the indicator flashes.
If you sell your vehicle, be sure to
erase the programs stored in the
HomeLink
®
memory.
4RUNNER_U.book Page 348 Wednesday, July 30, 2008 3:00 PM
To Next Page
Loading...
