Toyota Avalon 2019 - Parking Assistance Systems

24
FEATURES & OPERATIONS
If the sensors detect an obstacle, the buzzer and MID display informs the driver of
the approximate position and distance of the obstacle by illuminating continuously
(far) or blinking (near).
Note: Use
/ , / and
of the meter control switches to select
and
in the Multi-Information Display (MID) to change settings. The system
will continue in the last state it was in (ON or OFF) when the engine is started
again.
Refer to section Intuitive parking assist in the Owner’s Manual for more details.
When parking, this available system scans for stationary objects, like walls or
lampposts. Should the system anticipate a collision, it will emit an audible and
visible alert, reduce engine or motor output, and automatically apply the brakes
if needed. If your vehicle is equipped with ICS, the RCTA system will also have a
braking function that may apply the vehicle’s brakes if the system detects crossing
vehicles while the Avalon is backing up.
Note: Use / , / and of the meter control switches to select
and
in the Multi-Information Display (MID) to change settings. The system
will continue in the last state it was in (ON or OFF) when the engine is started
again.
Refer to the Owner‘s Manual for more details on this system.
System ON/OFF on the
Multi-Information Display.
CHANGE SETTINGS
INTELLIGENT PARKING ASSIST (IF EQUIPPED)
Intelligent Clearance Sonar with Rear Cross
Traffic Braking (ICS w/RCTB) (if equipped)
2019_Avalon_QRG_V3_3_ML_0406.indd 24 4/12/18 3:14 PM