AX0LI–03
D05876
Q04733
O–ring
D05887
Q04733
O–ring
–AUTOMATIC TRANSAXLE (U240E) SPEED SENSOR
AX–3
AVENSIS/CORONA SUP (RM781E)
SPEED SENSOR
ON–VEHICLE REPAIR
1. REMOVE AIR CLEANER ASSEMBLY
2. DISCONNECT COUNTER GEAR SPEED SENSOR
CONNECTOR
3. REMOVE COUNTER GEAR SENSOR
(a) Remove the bolt and counter gear speed sensor.
(b) Remove the O–ring from the counter gear speed sensor.
4. INSTALL COUNTER GEAR SPEED SENSOR
(a) Coat a new O–ring with ATF and install it to the counter
gear speed sensor.
(b) Install the counter gear speed sensor with the bolt.
Torque: 11.3 N·m (115 kgf·cm, 8 ft·lbf)
5. CONNECT COUNTER GEAR SPEED SENSOR CON-
NECTOR
6. DISCONNECT INPUT TURBINE SPEED SENSOR
CONNECTOR
7. REMOVE INPUT TURBINE SPEED SPEED SENSOR
(a) Remove the bolt and input turbine speed sensor.
(b) Remove the O–ring from the input turbine speed sensor.
8. INSTALL INPUT TURBINE SPEED SENSOR
(a) Coat a new O–ring with ATF and install it to the input tur-
bine speed sensor.
(b) Install the input turbine speed sensor with the bolt.
Torque: 11.3 N·m (115 kgf·cm, 8 ft·lbf)
9. CONNECT INPUT TURBINE SPEED SENSOR CON-
NECTOR
10. INSTALL AIR CLEANER ASSEMBLY
To Next Page
General
