EasyManuals Logo

Toyota Celica 1993 User Manual

Toyota Celica 1993
71 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
2.2L 4-CYL - VIN [S]
1993 Toyota Celica
1993 TOYOTA ENGINES
2.2L 4-Cylinder
Camry, Celica, MR2
* PLEASE READ THIS FIRST *
NOTE: For engine repair procedures not covered in this article,
see ENGINE OVERHAUL PROCEDURES - GENERAL INFORMATION article
in the GENERAL INFORMATION section.
NOTE: On Camry applications only, 2 balance shafts are located in
balance shaft assembly at bottom of cylinder block, below
crankshaft. The No. 1 balance shaft is driven by a drive
gear on No. 3 crankshaft counterweight. Balance shaft
assembly is used to reduce engine vibration.
ENGINE IDENTIFICATION
Engine serial number is stamped on flywheel/drive plate end
of cylinder block, below cylinder head surface.
ENGINE IDENTIFICATION CODES TABLE

Application Engine Code VIN Code
Camry, Celica & MR2
2.2L 4-Cylinder ............ 5S-FE ............... S

ADJUSTMENTS
VALVE CLEARANCE ADJUSTMENT
NOTE: Adjust valve clearance with engine cold.
1) Remove nuts, grommets, valve cover and gasket. Note
location of grommets for reassembly. Rotate crankshaft clockwise so
cylinder No. 1 is at TDC on compression stroke. Cylinder No. 1 is
front cylinder at timing belt end of engine.
2) Ensure timing mark on crankshaft pulley aligns with "0"
mark on timing belt cover. Ensure valve lifters are loose on cylinder
No. 1 and tight on cylinder No. 4. If conditions are not as described,
rotate crankshaft one complete revolution (360 degrees).
3) With cylinder No. 1 at TDC on compression stroke, check
valve clearance on specified valves. Perform STEP 1. See Fig. 1. Using
feeler gauge, measure and record valve clearance between valve lifter
and camshaft.
4) To check remaining valves, rotate crankshaft clockwise 360
degrees (one revolution) until cylinder No. 4 cylinder is at TDC on
compression stroke. Measure and record valve clearance on specified
valves. Perform STEP 2. See Fig. 1.
5) Ensure valve clearance is within specification. See VALVE
CLEARANCE SPECIFICATIONS table.
VALVE CLEARANCE SPECIFICATIONS (1) TABLE

Application In. (mm)

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toyota Celica 1993 and is the answer not in the manual?

Toyota Celica 1993 Specifications

General IconGeneral
BrandToyota
ModelCelica 1993
CategoryAutomobile
LanguageEnglish

Related product manuals