183
4-3. Operating the lights and wipers
4
Driving
1 Press the Automatic High
Beam switch.
2 Turn the headlight switch to
the or (if equipped)
position.
When the headlight switch lever is
in the low beam position, the AHB
system will be enabled and the
AHB indicator will illuminate.
■ Automatic operating condi-
tions of the high beams
● When all of the following condi-
tions are met, the high beams will
illuminate automatically:
• The vehicle speed is approxi-
mately 21 mph (34 km/h) or more.
• The area ahead of the vehicle is
dark.
• There are no vehicles ahead with
lights on.
• There are few streetlights or other
lights on the road ahead.
● If any of the following conditions
are met, the headlights will
change to the low beams:
• Vehicle speed drops below
approximately 17 mph (27 km/h).
• The area ahead of the vehicle is
not dark.
• There is a vehicle ahead with
lights on.
• There are many streetlights or
other lights on the road ahead.
■ Front camera detection
● In the following situations, the high
beams may not be automatically
changed to the low beams:
• When a vehicle cuts in front of
your vehicle
AHB (Automatic High
Beam)
The Automatic High Beam
uses a front camera located
on the upper portion of the
windshield to detect the
brightness of the lights of
vehicles ahead, street-
lights, etc., and automati-
cally changes the head
lights between the high
beams and low beams.
■ For safe use
Do not overly rely on the Auto-
matic High Beam. Always drive
safely, taking care to observe your
surroundings and turning the high
beams on or off manually if nec-
essary.
■ To prevent unintentional
operation of the Automatic
High Beam System
When it is necessary to disable
the system: P.194
Using the Automatic High
Beam system
To Next Page
Loading...
