234
4-5. Using the driving support systems
brake pedal is depressed.
(If the vehicle has been stopped by
system control, depressing the
brake pedal will not cancel control.)
2 Press the “RES” switch to
resume control.
Each time the switch is pressed, the vehicle-to-vehicle distance set-
ting will change as follows:
If a preceding vehicle is detected, the preceding vehicle mark will be dis-
played.
The actual vehicle-to-vehicle distance varies in accordance with the vehicle
speed. Also, when the vehicle is stopped by system control, it will be
stopped at a certain distance from the preceding vehicle, depending on the
situation, regardless of the setting.
■ Operating conditions
● The shift lever is in D.
● The desired set speed can be set
when the vehicle speed is approx-
imately 20 mph (30 km/h) or more.
• If the vehicle speed is set while
driving at below approximately 20
mph (30 km/h), the set vehicle
speed will be approximately 20
mph (30 km/h).
• If the vehicle speed is set while
driving at a speed that exceeds
the system’s upper limit, the set
vehicle speed will be the system’s
upper limit.
■ Accelerating after setting the
vehicle speed
As with normal driving, acceleration
can be performed by depressing the
accelerator pedal. After accelerat-
ing, the vehicle will return to the set
Changing the vehicle-to-vehicle distance
Illustration
Number
Vehicle-to-vehicle
distance
Approximate Distance (Vehicle
Speed: 60 mph [100 km/h])
1 Short Approximately 85 ft. (25 m)
2 Medium Approximately 100 ft. (30 m)
3 Long Approximately 145 ft. (45 m)
4 Extra long Approximately 200 ft. (60 m)
To Next Page
Loading...
