282
4-5. Using the driving support systems
■ The system will operate when
The function will operate when the
driving assist information indicator is
not illuminated or flashing (P.76,
405) and all of the following condi-
tions are met:
● Engine output restriction control
• PKSB (Parking Support Brake)
system is enabled.
• The vehicle speed is approxi-
mately 9 mph (15 km/h) or less.
• Vehicles which are approaching
from the right or left at the rear of
the vehicle at a traveling speed of
approximately 5 mph (8 km/h) or
more.
• The shift lever is in R.
• The PKSB (Parking Support
Brake) determines that a stronger
than normal brake operation is
necessary to avoid a collision with
an approaching vehicle.
● Brake control
• Engine output restriction control is
operating.
• The PKSB (Parking Support
Brake) determines that an emer-
gency brake operation is neces-
sary to avoid a collision with an
approaching vehicle.
■ The system will stop operating
when
The function will stop operating if
any of the following conditions are
met:
● Engine output restriction control
• PKSB (Parking Support Brake)
system is disabled.
• The collision becomes avoidable
with normal brake operation.
• A vehicle is no longer approaching
from the right or left at the rear of
the vehicle.
● Brake control
• PKSB (Parking Support Brake)
system is disabled.
• Approximately 2 seconds have
elapsed since the vehicle was
stopped by brake control.
• The brake pedal is depressed
after the vehicle is stopped by
brake control.
• A vehicle is no longer approaching
from the right or left at the rear of
the vehicle.
■ Detection range
The detection area of the system
differs from the detection area of the
RCTA function (P.259). Therefore,
even if the RCTA function detects a
vehicle and provides an alert, the
PKSB (Parking Support Brake) sys-
tem may not start operating.
■ Situations in which the system
may not operate properly
P.260
■ Situations in which the system
may operate even if there is no
possibility of a collision
P.262
To Next Page
Loading...
