Toyota MR2 SW 1993 User Manual

COOLANT REPLACEMENT
NOTICE:
• To avoid the danger of burns, do not begin work
until the engine and coolant have properly cooled
down.
• To ensure that coolant is poured in properly, per–
form the operation at a level area. Performing work
with the vehicle inclined may cause improper re–
moval of coolant or improper air removal when
pouring coolant.
• After replacing the coolant, check the water level in
the water filler and reservoir tank once or twice
within 500 km (311 miles) of driving or within one
week.
COOLANT CIRCUIT
–3S–GTE ENGINE COOLING SYSTEM
EG1–418

Toyota MR2 SW 1993 Specifications

General

Brand	Toyota
Model	MR2 SW 1993
Category	Automobile
Language	English

Summary

Coolant Replacement Procedures

Coolant Replacement Precautions and Checks

Safety warnings and post-replacement checks for engine coolant.

Coolant Drainage Process

Engine Coolant Drainage Steps

Procedure for draining engine coolant, including precautions and torque specifications.

Engine Coolant Refill

Preparation and Initial Filling

Steps for preparing the vehicle and starting the coolant refill process.

Coolant Filling and Air Bleeding

Detailed process for filling coolant and bleeding air from the system.

Final Filling, Engine Run, and Checks

Procedures for closing drain plugs, initial engine run, and topping up coolant.

Reservoir Fill and Reassembly

Filling the reservoir tank, checking for leaks, and reassembling vehicle components.