Toyota RAV4 2009 - Cruise Control; Downhill Assist Control System (DAC); Hill-Start Assist Control (HAC); Power Outlets-12 V DC

23
OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES
22
ON/OFF switch
Rear console
Push
NOTE: Engine switch/“ENGINE START STOP” switch must be in the “ON”
position to be used.
Power outlets-12V DC
Instrument panel
Inside center console
NOTE: Designed for car accessories. Engine switch/“ENGINE START STOP”
switch must be in the “ACC” or “ON” position to be used.
FEATURES/OPERATIONS
Cruise control
Turning system ON/OFF
Functions
System ON/OFF
Resume
2
/Increase speed
Set/Decrease speed
Cancel
1
1
The set speed may also be cancelled by depressing the brake pedal.
2
The set speed may be resumed once vehicle speed exceeds 25 mph.
Refer to the
Owner’s Manual for more details.
Luggage compartment
Downhill Assist Control system (DAC)
Power outlets-120V AC (if equipped)
DAC helps the vehicle to descend steep hills while maintaining a
low speed without brake pedal operation. P
ress the “DAC” button
(indicator will blink). Shift into L or R to activate (indicator will be solid).
Pressing the button again will turn system off.
Refer to the
Owner’s Manual for more details.
HAC helps prevent rolling backwards on an incline. To engage, push
further down on brake pedal while at a complete stop until a beep sounds
and slip indicator illuminates. HAC holds for approximately 2 seconds after
releasing brake pedal.
Refer to the
Owner’s Manual for more details.
Brake
pedal
Hill-start Assist Control (HAC)
(if equipped)