229
7
7-1. Phone operation (Hands-free system for cellular phones)
Phone
1 Display the phone top screen.
(P.218)
2 Select “Message” (“Messages”).
A confirmation message appears
when the “Automatic message
transfer” function is set to off
(P.240), select “Yes”.
3 Check that the message screen
is displayed.
“Phone”: Select to change to phone
mode.
The account name is displayed
on the left side of screen.
Account names are the names of
the accounts that exist on the
currently connected phone.
The following functions can be
used on message function:
• Receiving a message (P.229)
• Checking messages (P. 23 0)
• Replying to a message (P.230)
• Calling the message sender
(P.231)
• Message settings (P.240)
When an e-mail/SMS/MMS is
received, the incoming message
screen pops up with sound and is
ready to be operated on the screen.
Select to check the message.
Select to not open the message.
Select to call the message
sender.
● Depending on the type of Bluetooth
®
phone used for receiving messages,
or its registration status with the sys-
tem, some information may not be dis-
played.
● The pop-up screen is separately avail-
able for incoming e-mail and
SMS/MMS messages under the fol-
lowing conditions:
E-mail:
• “Incoming E-mail display” is set to
Bluetooth
®
phone mes-
sage function
Received messages can be for-
warded from the connected
Bluetooth
®
phone, enabling
checking and replying using
the system.
Depending on the type of
Bluetooth
®
phone connected,
received messages may not be
transferred to the system.
If the phone does not support
the message function, this
function cannot be used. Even
when the supported phone is
used, reply function may not
be used.
Displaying the message
screen
Receiving a message
To Next Page
Loading...
