107
2-2. Charging
2
Plug-in hybrid system
■ Unlocking the charging port
lid
1 Unlock the doors using the
smart key system or wireless
remote control.
2 Press the central rear edge
of the charging port lid (the
● The plug can be securely
inserted into the outlet.
● The plug does not get extremely
hot during use.
● The tip of the plug has not been
deformed.
● The plug is not dirtied by dust
etc.
Remove the plug from the outlet
before inspecting it. If any abnor-
malities are found in the AC
charging cable as a result of the
inspection, immediately stop use
and consult your Toyota dealer.
■ Maintaining the AC charging
cable
When the AC charging cable is
dirty, first remove the dirt with a
hard, wringed cloth, and then
wipe the cable with a dry cloth.
However, never wash it with
water. If the AC charging cable is
washed with water, fire or electric
shock may occur during charging,
possibly resulting in death or seri-
ous injury.
■ When not using the AC
charging cable for a long time
Remove the plug from the outlet.
Dust could accumulate on the
plug or in the outlet, possibly
causing overheating which could
lead to a fire.
Also, keep the cable in a place
free from moisture.
Locking and unlock-
ing the charging port
lid and charging con-
nector
The charging port lid and
charging connector can be
locked/unlocked by the fol-
lowing procedures.
Using the smart key sys-
tem
*
: P.198
Using the wireless remote
control
*
: P.196
*
: If the smart key system or the
wireless remote control does
not operate properly, use the
mechanical key. (P.537)
Locking and unlocking
the charging port lid
To Next Page
Loading...
