28
Dynamic Laser Cruise Control (if equipped)
FEATURES & OPERATIONS
FIXED SPEED MODE
DISTANCE CONTROL MODE
1
The set speed may also be cancelled by depressing the brake pedal.
2
The set speed may be resumed once vehicle speed exceeds 25 mph.
Distance control mode will cruise at a set speed, decelerate to maintain selected
distance from a slower vehicle traveling in front of you, and accelerate back up to
the selected speed if the vehicle traveling in front of you changes lanes or speeds
up.
(1) Once fixed speed control is set, you can set vehicle-to-vehicle distance.
(2) To change the vehicle-to-vehicle distance Push the Vehicle-to-vehicle
distance button to cycle through the settings, which will change progressively
from LONG to MIDDLE to SHORT.
NOTE: Once vehicle speed is set, pushing lever up toward “+ RES” will
increase speed to the nearest 5 mph, and then in 5 mph increments. Pushing
lever down toward “- SET” will reduce speed in the same way.
(1) To select conventional/fixed speed control Push the ON-OFF button once to
display the “CRUISE” indicator and a second time to display “RADAR READY”.
(2) To set, cancel and resume a speed Refer to instructions for Cruise Control in
this guide.
(1) (2)
Refer to the Owner’s Manual for more details and complete safety precautions
before attempting to use “Dynamic Laser Cruise Control.”
LONG
MIDDLE
(default)
SHORT
Preceding vehicle mark
Push “INFO” to change information in the following:
(1) Zoom display of odometer and trip meter
(2) Average gas mileage
(3) Current gas mileage
(4) Miles left on remaining fuel
(5) Running time from engine start
(6) Average vehicle speed
Push “SETUP” to customize to the following settings:
(1) Unit
(2) Keyless entry feedback
(3) Keyless entry relock timer
(4) Keyless entry all doors unlock
(5) Door auto locking
(6) Door auto unlocking
(7) Headlamps auto off timer
(8) Courtesy lamps off timer
(9) Language
(10) Default setting
2017_Sequoia_QRG_r1.indd 28 10/24/16 8:26 PM
To Next Page
Loading...
