240
4-5. Using the driving support systems
SEQUOIA_OM_USA_OM0C011U
■
Changing the pre-collision warning timing
The pre-collision warning timing can be changed on the multi-infor-
mation display as following:
The operation timing setting is retained when the engine switch is
turned off.
Press “<” or “>” of meter control switches and select .
Press “∧” or “∨” of meter control switches and select “PCS”, and
press .
Press “∧” or “∨” of meter control switches and select “Sensitivity”,
and press to select the desired setting.
Far
The warning will begin to
operate earlier than with the
default timing.
Middle
This is the default setting.
Near
The warning will begin to
operate later than with the
default timing.
1
2
3
To Next Page
Loading...
