34
TOYOTA SAFETY SENSE
™
CHANGING PCS ALERT TIMING
Far
Middle
(default)
Near
(1) Press “ ” or “ ” of meter control switches and select .
(2) Press “
” or “ ” of meter control switches and select “PCS”, and press .
(3) Press “
” or “ ” of meter control switches and select “Sensitivity”, and press
to select the desired setting.
Note: PCS is enabled each time the engine switch is turned to Ignition On.
The system can be disabled/enabled and the alert timing of the system can be
changed. (Alert timing only, brake operation remains the same).
Monocular camera sensor
Millimeter
wave radar
As part of the Pre-Collision System, this function is also designed to first provide an
alert and then automatic braking if needed.
In certain conditions, the PCS system included with the TSS-P package may also
help to detect a pedestrian in front of your vehicle. With Toyota Safety Sense™ P,
PCS uses an in-vehicle camera and front-grill mounted millimeter-wave radar to
help detect a pedestrian in front of your vehicle in certain conditions. The in-vehicle
camera of PCS detects a potential pedestrian based on size, profile, and motion of
the detected pedestrian. However, a pedestrian may not be detected depending
on the conditions, including the surrounding brightness and the motion, posture,
size, and angle of the potential detected pedestrian, preventing the system from
operating or engaging. Refer to a Toyota Owner’s Manual for additional information.
PCS PEDESTRIAN DETECTION
49195b_MY19_Sequoia_QRG_V1_ML_0718.indd 34 7/31/18 10:05 PM
To Next Page
Loading...
