’04 Tacoma U (L/O 0309)
201
2004 TACOMA from Sep. ’03 Prod. (OM35814U)
CAUTION
Make sure the floor mat is properly
placed on the floor carpet. If the floor
mat slips and interferes with the
movement of the pedals during driv-
ing, it may cause an accident.
Valance panel
Longer
tapping screws
Front license plate
Shorter
tapping screws
Install the front license plate using the
following procedure:
1. Remove and discard the front license
plate frame (if installed on the vehicle
at delivery).
2. Align the holes on the front license
plate with the dimples on the valance
panel.
3. Install the two longer tapping screws
through the upper holes, and the two
shorter tapping screws through the low-
er holes of the license plate, into the
dimples on the valance panel.
Do not drill holes in the dimples on the
valance panel.
The 4 tapping screws are enclosed in a
plastic bag in the glove box. If your ve-
hicle was not equipped with the screws at
delivery, contact your Toyota dealer.
Installing front license plate
(four- wheel drive models and
Pre Runner)
To Next Page
Loading...
Need help?
General
