Toyota TVSS IV-S User Manual

TOYOTA MOTOR CORPORATION
CELICA (LHD)
TEILENUMMER - PART NUMBER - NUMERO DE PIECE
HAUPT-EINBAUSATZ
MAIN KIT 08585-12910
EQUIPEMENT PRINCIPAL
EINBAUSATZ
FITTING KIT
08586-2D841
KIT DE MONTAGE
STATUSANZEIGE
STATUS MONITOR A
08192-42840
TEMOIN DU CONTROLE D’ETAT
STATUSANZEIGE
STATUS MONITOR B Application:When switch base is used.
08192-1A990
TEMOIN DU CONTROLE D’ETAT
GLASBRUCHSENSORSATZ
GLASS BREAKAGE SENSOR KIT I Application:When switch base is unused.
08192-42870
KIT DU DETECTEUR DE BRIS DE VITRE
GLASS BREAKAGE SENSOR KIT II Application:When switch base is used.
08192-14820
RADARSENSOR
RADAR SENSOR 08192-00920
DETECTEUR A RADAR
FÜR-FOR-POUR
**
T23
*
L
Pdf ADPA 2T4LT23/J-A0-1.pdf
ALARM
TOYOTA VEHICLE SECURITY SYSTEM
TT VVSS SS II VV -- SS
09/23/02
EINBAUANLEITUNG
INSTALLATION INSTRUCTIONS
NOTICE EXPLICATIVE DE L’INSTALLATION
für - for - pour

Toyota TVSS IV-S Specifications

General

Brand	Toyota
Model	TVSS IV-S
Category	Security System
Language	English

Summary

Safety Precautions

Battery Disconnection and Handling

Ensure battery negative terminal is disconnected before installation.

Wiring and Connector Precautions

Proper routing, protection, and connection of wiring and connectors are critical.

Installation Best Practices

Use appropriate tools, protect vehicle interior, and verify component security.

Vehicle Preparation for Installation

Interior Trim and Console Disassembly

Steps for removing interior panels, trim, and console for access.

TVSS ECU Mounting

ECU and Bracket Installation

Connect the TVSS ECU and attach its protective mounting bracket.

Wire Harness Installation

Routing and Connecting Harness

Route and connect the main system wire harness throughout the vehicle.

Glass Breakage Sensor Unit Installation

Sensor Unit Mounting and Connection

Install and connect the glass breakage sensor control unit.

Radar Sensor Installation

Sensor Mounting and Adjustment

Install the radar sensor, adjust sensitivity, and secure its bracket.

Status Monitor Installation (No Glass Sensor)

Monitor Fitting and Wiring

Fit the status monitor indicator and connect wiring for models without glass sensor.

Status Monitor Installation (With Glass Sensor)

LED Indicator Mounting and Wiring

Install the LED indicator and connect wiring for models with glass sensor.

Microphone Mounting

Attaching and Connecting Microphone

Mount the microphone unit and connect its wiring harness.

Final Steps

Attaching System Stickers

Clean and apply system stickers to the interior of the front windows.