6
Method B: Take two 1.5V AA batteries (batteries not
enclosed) in accordance with the direction to
install inside the battery of the remote control,
close the batteries cover.
Note: do not install backwards the battery, do not mix the
new and old batteries or dierent types of batteries.
Bind Frequency and adjust the acceleration
1. Power on the aircraft
Insert the battery into the power inserting mouth in the
battery, and cover well the battery, open the power supply
on the tail, at this time the LED lights of the aircraft begin
ashing, place the aircraft on a at ground or object to
adjust by the gyroscope, (if not at, after adjustment will
aect the ight eect )
2. Open the power supply of the remote control, the
indicator light starts ashing, push the left rocker of
the remote control to the upper then push to the
bottom (as shown in the below picture), at this time
enter into the searching frequency state, when the
LED lights of the aircraft turn to normal light, it
shows that the success of frequency.
To Next Page
Loading...
Need help?
General