TP-Link Archer C6 - Quick Installation Guide Manual

Quick Installation Guide
Wireless Dual Band Router
* Images may dier from actual products.
If your internet comes from an Ethernet outlet, connect the router’s Internet port to it, then follow Step 4 and Step 5.
If you want to configure this new router as an access point to extend your network, refer to the Access Point Mode
section on the back page.
Connect the Hardware
Flip the page over to complete network setup.
Connect the power adapter to
the router and turn it on.
Note: If the 2.4 GHz LED and 5 GHz LED are off, press and hold the
WPS/Wi-Fi On/Off button on the back for more than 3 seconds. Both the
LEDs should turn on.
Power
On
Internet
On
2.4 GHz
On
5 GHz
On
Check for the following LEDs to confirm the
hardware connection, then refer to the next
section to set up the internet.
Modem
Power adapter
Router
Unplug your modem, and remove
the backup battery if it has one.
Connect the powered-off modem
to the router’s Internet port with an
Ethernet cable.
Power on the modem, and
then wait about 2 minutes
for it to restart.
Internet
Power
Power adapter
Power On / O
Set up with videos:
Scan the QR code or visit
https://www.tp-link.com/support/setup-video/#wi--routers
to search for the setup video of your product.