NC230 HD Day/Night Wi-Fi Cloud Camera
HD Day/Night Cloud Camera, 300Mbps Wi-FiNC25
0
40
Reboot: Click Reboot and then click Reboot on the pop-up screen to confirm. Rebooting will
not change the camera’s setting. After rebooting, you need to log in to this page again.
Backup: Click Backup and follow the instructions on the browser to save the setting data file
to your specified location.
Restore: Click Browse to locate the saved backup file and then click Restore. The camera
will start rebooting and then the settings will be restored to the previous configuration.
Reset: Click Reset and then click Reset on the pop-up screen to restore the camera to its
factory defaults. Don't turn off the camera while resetting. After resetting, you need to find out
the IP address of your camera (refer to 4.1 Log in to Your Camera
) and use the default
username and password (admin/admin) to log in to this page.
Update: Before update, download the latest firmware from the product page at
http://www.tp-link.com
, and then use decompression software to extract the file. Click Browse
to locate the latest downloaded software file, and then click Upgrade to update the camera’s
software to the latest version. Wait for the upgrading process to complete, and the camera will
reboot automatically.
Note:
1. We recommend that you use a wired connection for your camera and PC when upgrading
firmware.
2. The firmware upgrade procedure must not be interrupted or the camera may be damaged.
3. The firmware upgrade procedure is always risky and do not try to upgrade new firmware if it’s
To Next Page
Loading...
