Configuring Logical Interfaces Logical Interfaces Configurations
Configuration Guide
381
Figure 2-3 Configuring the IPv6 Parameters
1) Enable IPv6 function on the interface of switch in the General Config section. Then
click Apply.
Interface ID Displays the interface ID.
IPv6 Enable or disable IPv6 function on the interface of switch.
2) Configure the IPv6 link-local address of the interface manually or automatically in the
Link-local Address Config section. Then click Apply.
Config Mode Select the link-local address configuration mode.
Manual: With this option selected, you can assign a link-local address manually.
Auto: With this option selected, the switch will generate a link-local address
automatically.
To Next Page
Loading...
