Read this to install additional devices
1� Make sure the additional devices use factory default settings� If
not, please reset them�
2� Plug them into the outlets and wait about 1 minute until their
Powerline LEDs turn solid�
AV500 AV500 AV500
Installation is completed when all the
Powerline LEDs turn solid�
Additional Device
TL-WPA4220TL-WPA4220
TL-PA4010
If the Powerline LEDs do not turn solid, please follow the instructions in
FAQ
->
Q1:
1� For the two devices connected before, use the Pair Button to create a
powerline network (Q1
->
A)� (Skip this step if you have already done this�)
2� For additional devices, use the Pair Button to join the existing powerline
network (Q1
->
B)�
Method 2: Setup via Wi-Fi Clone
Extend the Router's Wireless Network
1� Plug TL-WPA4220 into a wall socket near your router�
AV500
TL-WPA4220
Blink quickly in about
15 seconds�
Wireless Router
(supporting WPS)
To Next Page
Loading...
