TP-Link TL-WR543G - Advanced Wireless Settings; Site Survey

TL-WR543G 54M Wireless AP Client Router User Guide
- 33 -
2. Access the AP's Web-based utility and configure the AP under Bridge mode, then input
00-13-56-A8-9E-1A in corresponding Blank.
)
Note:
If Bridges is enabled in AP Client mode, there is only one Security Type (WEP) for you to encrypt
the wireless network. Otherwise, there are three Security Type (WEP, WPA-PSK/WPA2-PSK
and WPA/WPA2).
Be sure to click the Save button to save your settings on this page.
)
Note:
The router will reboot automatically after you click Save.
4.6.2 Advanced Settings
This page shows some advanced settings about this router for you.
Figure 4-18
¾ XR - The short of eXtended Range™. If enabled, the wireless transmission distance will be
longer in the same condition of circumstance.
¾ Power - The transmit power of the access point. There are five options for you to select in
the pull-down list: Max, 1/2, 1/4, 1/8 and Min.
)
Note:
The router will reboot automatically after you click the Save button.
4.6.3 Site Survey
This Page shows the site list of scanning result, and you can choose one to connect to.