REV1.0.0
7106505861
1 Set the Operation Mode Switch to Router/AP.
2 Connect the router according to steps A to C in the left diagram.
3 Connect your device to the router wirelessly or via an Ethernet cable. The Wi-Fi network name
and password is on the router’s label.
4 Launch a web browser and type http://tplinkwifi.net into the address bar. Enter admin (in
lowercase) for both user name and password to log in.
5 Click Quick Setup on the left panel and click Next to start configuring the router. Select
Standard Wireless Router mode and click Next.
6 Select the WAN Connection Type of your Internet Service Provider and follow the screen
instructions to configure the router. When using the router in a hotel room or in a small office,
select Dynamic IP.
7 On the Wireless screen, either keep the default Wireless Network Name and Password or
customize them, then click Next.
8 Click Finish to complete the configuration.
Configure the Router
Meet Your Router
Standard Wireless Router
Access Point
Standard Wireless Router
Access Point
Repeater
Client
To share a wired (Ethernet) connection to wireless devices, such as in a hotel room, small office, etc.
To set up a Wi-Fi network from an existing wired (Ethernet) network.
To extend the range of an existing Wi-Fi network.
To function as a wireless adapter to connect your wired device (e.g. Blu-ray® player, smart TV, or game console) to a wireless network.
Operation Modes Application
1 Set the Operation Mode Switch to Router/AP.
2 Connect the router according to steps A to C in the left diagram
.
3 Connect your device to the router wirelessly. The Wi-Fi network name and password is on the
router’s label.
4 Launch a web browser and type http://tplinkwifi.net into the address bar. Enter admin (in
lowercase) for both user name and password to log in.
5 Click Quick Setup on the left panel and click Next to start configuring the router. Select
Access Point mode and click Next.
6
On the Wireless Setting screen, either keep the default Wireless Network Name and
Wireless Password or customize them, then click Next.
7 Select the LAN IP type of the router or you can leave Smart IP as the default setting for most
cases, and click Next.
8 Click Reboot to complete the configuration.
Description
Interface
Connects a USB storage device for sharing or connects a mobile device
to charge.
USB
WPS/Reset
Button
Press this button to connect devices via the WPS (Wireless Protected
Setup) method.
Press and hold for 5 seconds to restore the router to its factory default
settings. Refer to the FAQ section for instruction.
LAN/WAN
Functions as the LAN port in Access Point, Repeater and Client mode.
Functions as the WAN port in Standard Wireless Router mode.
LAN
Connects an Ethernet-enabled device to the local network.
IndicationLED Status
Solid
The router is ready for operation.
Blinking The router is booting or connecting to an Ethernet device.
Determine Operation Mode
300Mbps Wi-Fi Pocket Router/AP
/TV Adapter/Repeater
MODEL NO. TL-WR810N
Quick
Installation Guide
Operation Mode
Switch
LAN/WAN
LAN
D
A
B
C
TL-WR810N’s
Wi-Fi Name:
TP-LINK_XXXX
Internet
TL-WR810N’s
Wi-Fi Name:
TP-LINK_XXXX
or
Internet
LAN
A
B
C
Wired Router
WPS/Reset
LAN/WAN
LAN
USB
LED
To Next Page
