TP-Link VIGI C540-W - User Manual

Quick Start Guide
*Images may dier from actual products.
Appearance
Power Supply Interface
(12V DC)
5
Status LED
6
7
White LED
2
RJ45 Network Interface
Infrared LED
3
Built-in Microphone
4
1
1
2
3
4
5
Package Contents
Network Camera
Waterproof Cable
Attachments
Quick Start Guide
Quick
Start
Guide
Option 1: Wall/Ceiling Mounting
1. Stick the mounting template to the desired mounting place. Drill 4 screw holes
according to the template.
2. Insert the anchors into the holes, use the provided screws to x the camera’s
bracket to the wall or ceiling.
Installing Waterproof Cable Attachments
Wall Mounting
Install the waterproof cable attachments for the network interface when the
camera is installed outdoors.
Note: Make sure each part is securely attached and the waterproof rings are ush to keep out water.
1. Route the network cable through the following components in order: x nut,
waterproof ring, and then the waterproof jacket.
2. Fix the O-ring to the network interface of the camera and connect the network
cables.
3. Attach the network interface with the waterproof jacket, then twist to lock.
4. Insert the waterproof ring into the waterproof jacket. Rotate the x nut to
secure it to the waterproof jacket.
1
Mount Camera
Fix Nut
Waterproof
Ring
O-ring
Network
Interface
Waterproof
Jacket
OR
Mounting Template
Anchor
Self-tapping Screw
Anchor
Self-tapping Screw
Mounting Template
Option 2: Pole Mounting
1. Thread each of the two cable ties through the slits on the back of the camera’s
bracket indicated below.
2. Slip the two cable ties through the pole. Tighten them to rmly attach the pole.
Cable Tie
Cable Tie
6
Status LED Indication
Note: Make sure that the wall is strong enough to withstand 3 times the
weight of the camera and mounting bracket .
7
Speaker
8
Micro SD Card Slot
Insert a micro SD card for local storage. Initialize the SD card via VIGI app before
recording videos.
9
Reset Button
Long press the button to reset the camera to factory settings.
8
9
Note: Before inserting the micro SD card or resetting
the camera, rotate the sphere and unfasten the two
xed screws to remove the cover.
Mounting Template
Anchors x 4 Screws x 4
©2022 TP-Link 7106509847 REV2.0.0
VIGI Wi-Fi Network Camera
Status Description
Solid red Starting up
Blink red and green Ready for setup
Blink green slowly Connecting to Wi-Fi
Solid green Connected to Wi-Fi
Blink red slowly Wi-Fi connection lost
Blink red quickly Camera resetting
Blink green quickly Camera updating
Install the waterproof seal for the power connectors when the camera is installed
outdoors.
Install Waterproof Seal for Power Connectors
Male Power Connector Waterproof Seal
Female Power Connector
Waterproof Seal
Power Adapter

Summary

Appearance and Components

Status LED

Indicates the camera's operational status, such as starting up or connecting to Wi-Fi.

Camera Mounting

Wall or Ceiling Mounting

Instructions for attaching the camera to walls or ceilings using screws and anchors.

Pole Mounting

Instructions for mounting the camera to a pole using cable ties.

Waterproof Connection Installation

Waterproof Cable Attachments

Steps to install waterproof seals for network interfaces for outdoor use.

Waterproof Seal for Power Connectors

Steps to install a waterproof seal for the camera's power connectors.

Camera Setup and Management

Download TP-Link VIGI App

Guidance on downloading the VIGI app from app stores for initial setup.

Power On Camera

Activate and Add Camera

Troubleshooting and FAQs

Configuration Failure

Camera Reset Procedure

Password Recovery

SD Card Issues

TP-Link VIGI C540-W Specifications

General

Sustainability certificates	CE, RoHS
Built-in microphone	Yes
Ethernet LAN (RJ-45) ports	1
Lens diameter	4 mm
DC output voltage	12
Power source type	PoE
Power consumption (Power over Ethernet (PoE))	14 W
Operating temperature (T-T)	-30 - 60 °C
Bluetooth	No
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Ethernet interface type	Fast Ethernet
Supported network protocols	TCP/IP, UDP, ICMP, HTTP, HTTPS, DHCP, DNS, RTSP, NTP, UPnP UDP, SSL/TLS
Number of simultaneous live view channels	3 channels
Total megapixels	4 MP
Maximum resolution	2560 x 1440 pixels
Image quality adjustment	Brightness, Contrast, Mirror, Saturation, Sharpness
Video compression formats	H.264, H.264+, H.265, H.265+
Noise reduction technology	3D noise reduction
Supported graphics resolutions	320 x 240, 352 x 288, 640 x 480 (VGA), 1920 x 1080 (HD 1080), 2048 x 1280, 2304 x 1296, 2560 x 1440
Compatible memory cards	MicroSD (TransFlash)
Maximum memory card size	256 GB
Security algorithms	WPA, WPA2-PSK
Intelligent Video Surveillance (IVS) system features	Human detection
Sensor type	CMOS
Optical sensor size	1/3 \
Behavior analysis	Intrusion detection, Line crossing detection
Pan range	0 - 350 °
Tilt angle range	0 - 120 °
Form factor	Turret
Mounting type	Ceiling/wall
Product color	Black, White
Housing material	Plastic
International Protection (IP) code	IP66
LED type	IR
Night vision distance	30 m
Type	IP security camera
Certification	RCM, BSMI, VCCI, NCC, JRF, KC
Placement supported	Indoor & outdoor
Connectivity technology	Wired & Wireless

Weight and Dimensions

Depth	172 mm
Width	120 mm
Height	198 mm
Package width	163 mm
Package height	243 mm
Package weight	1210 g