TP-Link XZ000-G3 - User Manual

Quick Installation Guide
Connect the Hardware
Register the Terminal
Connect to the Internet
1-Port Gigabit GPON Terminal
XZ000-G3
Establish your internet connection according to your ISP's instructions.
Note: If you need assistance, contact your ISP.
If the PON LED is solid on, please skip to Connect to the Internet.
B
Go to Network Setting > PON Certification. Enter the
GPON Password and/or GPON SN provided by your ISP
(Internet Service Provider) to register the Terminal and
click Save.
(0)characters
GPON Password
GPON Password(Notice: Maximum 10 ASCII characters)
Old Password:
New Password:
Save
GPON SN
GPON SN(Notice: Must be 16 Hexadecimal Numbers)
Old SN:
New SN:
Save
PON Certication
21
Power adapter
Terminal
Enjoy!
http://192.168.1.1
admin
Login
admin
POWER RESET LAN PON
Internet
Verify that the hardware connection
is correct by checking these LEDs.
3
Power: On
PON: On or Flashing
LOS: O
1
Connect your computer to the Terminal via an Ethernet cable.
3
Register the Terminal via a web browser.
Ethernet Cable
POWER RESET
LAN PON
A
Launch a web browser and type in http://192.168.1.1 in the
address bar. Use admin for both username and password to
log in to the Terminal.
If the Terminal’s LAN IP address is 192.168.1.1, please type
in IP address 192.168.1.x (x is from 2 to 253), subnet mask
255.255.255.0, and default gateway 192.168.1.1.
©2022 TP-Link 7109505590 REV2.0.1
2
Configure TCP/IP Properties manually on your computer.

TP-Link XZ000-G3 Specifications

General

Product type	Optical network terminal (ONT)
Product color	Black
LED indicators	Yes
ITU standards	G.984.1, G.984.3, G.984.4
Networking standards	IEEE 802.1Q, IEEE 802.1p, IEEE 802.3u
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Transmission distance (max)	20 km
Wi-Fi	-
Fiber ports quantity	1
Fiber optic connector	SC
Output current	0.6 A
Output voltage	9 V
Sustainability certificates	RoHS
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	75 mm
Width	95 mm
Height	29.3 mm

Summary

Connect the Hardware

Verify Hardware Connection LEDs

Check Power, PON, and LOS LEDs for correct status after connecting the terminal.

Connect Computer to Terminal

Connect your computer to the Terminal using an Ethernet cable.

Configure TCP;IP Properties

Manually set IP address, subnet mask, and default gateway on your computer.

Register Terminal via Web Browser

Access the terminal's web interface to enter PON details for registration.

Connect to the Internet

LED Indicators

Power LED Status

Details the status and indication for the Power LED.

PON LED Status

Details the status and indication for the PON LED.

LOS LED Status

Details the status and indication for the LOS LED.

LAN LED Status

Details the status and indication for the LAN LED.

Troubleshooting Common Issues

Cannot Access Web Management Page

Steps to resolve issues accessing the terminal's web management interface.

Cannot Access Internet

Steps to resolve issues with internet connectivity after setup.

Restore Factory Default Settings

Instructions on how to reset the terminal to its factory default settings.