(2) holes per
fastener type.
(2) sheet-metal screws
for steel duct (incl.)
(2) toggle-bolts
for ber/foam duct (incl.)
Green LED
indicates power
ON, and ionizer
operating.
35/8
”
Ø
To ensure lasting performance and maximum benefits:
1. In first year of operation, visually inspect quarterly. Clean away
any construction dust that may have accumulated on stingers.
2. An annual visual inspection is recommend. Adjust inspection
frequency per conditions of zones served.
3. If you see a build up of dust, spray needlepoints clean with a
compressed gas duster available at a retail office supply. In cases of
heavy dust build-up, use a soft cloth with isopropyl alcohol.
4. Your system's filters may gather a lot of dust following initial
startup and subsequent first cleanup of air in zone serviced by your
ionizer. Filter change frequency should normalize after 2 or 3 filter
cha n g es .
1. Green power ”ON” light not lit:
Verify 24v power supply functioning.
Check fuse (under black twist-off cap).
2. No ionization detected:
Confirm legs are free of dust build-up.
If power, fuse, and CPG legs look good,
contact a local Phenomenal Aire rep. :
Warranty, page 4.
Phenomenal Aire requires little or no maintenance!
Where to install your Phenomenal Aire Ion Generator:
Mount your ionizer so that the legs extend through a 3-5/8” hole
in your duct wall, are oriented in line with air flow per diagram
below, and that the ionizer body and mounting tabs are flush
against the exterior face, ready for fasteners. Hardware is
supplied for both metal and fiber duct construction.
Installation
Afte r any particulate system filter, and b e fo re the cooling coil.
Any system filter in place downstream of your ionizer may reduce
the volume of ions from delivering maximum benefits to your living/
work spaces. Free ions cause fine particulates to ”clump together”
and collect in your return-air filter media.
Your ionizer will also clean and protect your coils from contamination
by bacteria, viruses and mold.
After the cooling coil, in a dry, condensation-free area.
At supply air discharge, beyond any final filtration.
filter media
coils
Best:
Good:
Location
Trouble Shooting:
To Next Page
Loading...
Need help?
General