20
User’s manual
EN
Tracer eXplore
SJ 4060 + WiFi
Instructions for use
1. Insert TF card into the port
Make sure to insert the card with the top side facing the screen. The bottom
of the card with the connectors should be directed towards the front of the
camera.
2. Installation and replacement of batteries
• Slide the battery lock and at the same time open the battery cover.
• Insert the battery in the correct position, so that the battery termi-
nals +/- t the connectors on the camera. After inserting the battery,
close the battery cover.
• The battery indicator on the monitor screen shows the battery level.
• In order to replace the battery, open the battery compartment, as in
point A, and remove the batteries by pulling on the tie. Insert new
battery, proceeding as in point B.
3. Charging
• The batteries in Tracer eXplore SJ 4060+ WiFi may be charged by
connecting the device to any USB port on the computer via USB
cable or using the charger included in the kit.
• The camera may be charged in the car, using a micro USB 5V
charger.
• The camera may be used to record while charging.
4. Turn ON/OFF
• Press and hold the ON/OFF button for 3 to 5 seconds to turn the
camera on and off.
• The screen will switch off automatically, according to MENU set-
tings. In order to turn the screen back on, press OK.
• Press the ON/OFF button briey to turn the camera off.
To Next Page
Loading...