STEP TWO: Installation
Estimated time required for installation: 30 to 45 minutes for
experienced installer – 1 to 2 hours for novice.
It is recommended you use a professional car
electrician to install your tracker. However, if you're
handy, you may choose to install it on your own.
Tools needed for installation: voltage tester/meter,
wire stripper, electrical tape, wire connectors, fuse
taps.
Basic wiring diagram
The tracker has to be connected to a power source
providing 9V-30V DC. The wiring should be
connected to constant power for best results. The
power consumption is minimal (<30mA), and should
not affect your vehicle battery, unless the vehicle is
not used for an extended period (several weeks)or
the vehicle battery is in poor condition.
To Next Page
Loading...