The wiring harness has ten wires(approximately 3ft
long). First, you connect the black(fused) wire to
ground. The red and purple wires should be
combined and connected to a constant power source
(fuse or wire) providing between 9V and 30V. Finally,
the green wire has to be connected to ignition or any
fuse/wire that are powered by ignition.
IMPORTANT INFORMATION:
The SIM card is protruding:push it in and the LED
light on the device turns on. It will start working on
its internal back up battery (up to 6 hours). Secure
both antennas to the tracker as indicated. The GPS
antenna (about 10ft long) to the GPS coaxial
connector and the short, stubby antenna to the GSM
connector. Initially, the LED light will flash red. After
several minutes it will turn to a steady blue with red
flashing in the background. This indicates that
thetracker is transmitting tracking information.You
can test your device before actually installing it by
checking off the “Installed” box online. In order for
your device be able to start tracking it must be
outdoors, under the visible sky.Your device will
usually start tracking within the hour.Upon
completion of your test, you should uncheck the
“installed” box if you don’t intend to finish your
installation on the same day.You can let the internal
battery run out, it will not affect its installation.
The SIM card is pushed in: the internal battery is
depleted. In order to test your device, you must
attach the wiring harness and connect the following
wires to either a portable battery(<9V) or your
vehicles battery: red to + and black (with fuse) to -.
Secure both antennas to the tracker as indicated.
To Next Page
Loading...