Tractel dynafor LLXh Series User Manual (English)

Questions and Answers:

M
moniqueparkAug 4, 2025
What to do if the display evolution is inconsistent on my Tractel Measuring Instruments?
- M
  Megan TorresAug 4, 2025
  If the display of your Tractel Measuring Instrument is not showing any changes or is showing inconsistent data, it could be due to a sensor or sensor electronics malfunction. Try resetting the device by switching off both the sensor and the display unit, then switch on the sensor first, followed by the display unit. If the problem continues, it is recommended to contact the after-sales service.
S
Samuel WelchAug 9, 2025
Why won't the sensor on my Tractel Measuring Instruments switch on?
- B
  Barry MeyersAug 9, 2025
  If your Tractel Measuring Instrument sensor isn't turning on, it could be due to dead batteries or an electronic fault. First, try changing the batteries. If that doesn't solve the problem, you should contact the after-sales service for further assistance.
A
Anthony MooreAug 14, 2025
What to do if the display unit of my Tractel Measuring Instruments does not switch on?
- A
  Andrew JohnsonAug 14, 2025
  If the display unit of your Tractel Measuring Instrument isn't turning on, the power pack might be dead or there could be an electronic fault. Try charging the power pack. If the issue persists, contact the after-sales service.
R
Rodney JohnsonAug 19, 2025
How to fix an ineffective display on Tractel Measuring Instruments?
- J
  Janice GreeneAug 19, 2025
  If the display of your Tractel Measuring Instrument is ineffective, it means that the display is malfunctioning. You should keep the ON/OFF key pressed for 10 seconds and reboot both the load cell and the display.
M
moniquetaylorAug 25, 2025
Why is there no initial reset on my Tractel Measuring Instruments?
- P
  Paul WilliamsAug 25, 2025
  If your Tractel Measuring Instrument doesn't reset initially, it might be because the Tare Function is enabled, or there's permanent deformation of the sensor due to a handling error, excessive overload, or compression. You should disable the Tare function to display the "GROS" stress value. Before continuing to use the appliance, it should be checked by the manufacturer.
R
Ryan KingAug 29, 2025
What to do if sensor LED flashes at 4 hertz on Tractel Measuring Instruments?
- P
  Phyllis FoxAug 29, 2025
  If the sensor LED on your Tractel Measuring Instrument flashes at 4 hertz (4 times per second), there is no communication between the sensor and its electronic board. It is recommended to contact the after-sales service.