Tractel tirak X 300 P Series User Manual

138 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

tirak™

Electrically driven hoists for wire ropes for passenger transportation

(for TSP – personnel lifting equipment set up temporarily)

Elektrisch angetriebene Winden für Drahtseile zur Personenbeförderung

(für TSP – vorübergehend errichtete Personenaufnahmemittel)

Treuils à transmission électrique pour câbles métalliques pour le transport des personnes

(pour TSP – plate-forme à niveau variable construite provisoirement)

Elektrisch aangedreven lieren voor draadkabels voor het personentransport

(voor TSP – tijdelijk gebruikt personenopnamemiddel)

00381/1

Model series /

Typenreihe /

Série /

Serie

L 500 P

Model series /

Typenreihe /

Série /

Serie

X 300 P, X 400 P, X 500 P, X 520 P

X 600 P, X 620 P, X 820 P, X 1030 P

Model series /

Typenreihe /

Série /

Serie

X 2050 P

Original Operation and

Installation Manual

Manuel d´installation et de

manutention original

Original-Montage- und

Betriebsanleitung

Originele montage- en

bedieningshandleiding

Table of Contents

Questions and Answers:

P
Phillip NelsonAug 22, 2025
What to do if Tractel Lifting Systems motor starts but the wire rope does not move?
- K
  Kelly SmithAug 22, 2025
  If the motor starts but the wire rope doesn't move, it could be due to a rope jam caused by damaged or incorrect wire rope, or an obstructed rope exit. Here's what to do: 1. Support the load, for example, with a wedge clamp or lever hoist. 2. Cut the wire rope in front of and behind the hoist. 3. Send the hoist to be repaired. 4. When available, install a new wire rope in replacement hoist.
S
Stephanie HammondAug 25, 2025
Why does Tractel Lifting Systems motor switch off suddenly after prolonged use?
- B
  brandtkennethAug 25, 2025
  The motor may switch off suddenly after extended use due to overheating from inadequate cooling, supply voltage being too high or low, an ambient temperature exceeding 40°C, or operation at altitudes over 1000 m above sea level. To resolve this: * Ensure sufficient cooling. * Have an electrician measure the voltage and power consumption under load. * Provide sufficient breaks in operation.
K
Kelly WardAug 27, 2025
What to do if Tractel Lifting Systems suspended load continues to lower slowly when stopped?
- C
  Catherine CollinsAug 28, 2025
  If the suspended load continues to be lowered slowly when stopped, it might be due to a defective or dirty operating brake (spring-loaded brake) or an incorrect wire rope diameter. Here's what you should do: * Lower the suspended load down to the ground. * Send the hoist to the manufacturer for repairs or hand over to a specialist hoisting gear workshop. * Replace incorrect wire ropes with specified wire ropes.
C
Christine CisnerosAug 30, 2025
What to do if Tractel Lifting Systems motor hums intensively or the rope drive creaks?
- S
  shannon75Aug 30, 2025
  If the motor hums intensively or the rope drive creaks, even though UP and DOWN travel is possible, it could be due to: * The brake not opening because the power supply, brake coil, or rectifier are defective. Have these components checked by an electrician and repaired or replaced. * The brake not opening because the brake rotor is worn. Send the hoist to the manufacturer for repairs or a specialist hoist workshop. * Dirt in the rope drive, or damage to the wire rope and rope drive. Replace the hoist as soon as possible and have it checked or repaired by TRACTEL Greifzug GmbH or an authorized hoisting gear workshop.
S
stevensjustinAug 31, 2025
What to do if Tractel Lifting Systems load cannot be lowered or slackened?
- M
  Michael JenkinsAug 31, 2025
  If the load cannot be lowered or slackened, this could be because the load has come to rest on or jammed against an obstacle. Carefully move the load upwards to remove the obstacle. Then, check the wire rope, rigging, and lifting equipment to ensure they are still safe to use.
J
James LeeSep 2, 2025
What to do if Tractel Lifting Systems load has jammed or is tied in place?
- M
  Margaret MossSep 3, 2025
  If the load has jammed or is tied in place, carefully free or untie the load. After doing so, check the wire rope, rigging, and load lifting equipment to ensure they are still safe for operation.
P
Pedro WangSep 8, 2025
Why does my Tractel Chain Hoists motor hum or rope drive creak?
- A
  April WadeSep 8, 2025
  If the motor hums intensively or the rope drive creaks, even though UP and DOWN travel is possible, it could be due to: * Overheating caused by deficient motor cooling. Provide sufficient cooling. * Overheating due to the voltage being too high or too low. Have an electrician measure the voltage and power consumption when subjected to load. Increase the wire cross-section if necessary. * Dirt in the rope drive, which could damage the rope and rope drive. Replace the hoist as soon as possible and have it checked or repaired by TRACTEL Greifzug GmbH or an authorized hoisting gear workshop.
J
Joe DaltonSep 10, 2025
What to do if suspended load continues to be lowered slowly when stopped with Tractel Chain Hoists?
- E
  Eileen MendozaSep 10, 2025
  If the suspended load continues to be lowered slowly when stopped, it could be due to: * A defective or dirty operating brake (spring-applied brake) on the hoist. Lower the suspended load down to the ground and send the hoist to the manufacturer for repairs or hand it over to a specialist hoisting gear workshop. * An incorrect rope diameter or a rope diameter that is too small. Replace incorrect ropes with specified ropes.
M
Megan JacksonSep 12, 2025
What to do if Tractel Chain Hoists load cannot be lowered but the rope can be lifted?
- L
  lflynnSep 12, 2025
  If the load cannot be lowered or slackened although the rope can be lifted or pulled: * The load may have come to rest on an obstacle or has jammed on an obstacle. Carefully move the load upwards and remove the obstacle. Check the rope, rigging and lifting equipment to confirm their operating safety. * There may be a fault in the DOWN control circuit of the hoist. Trigger emergency descent by releasing the brake and have the connections, wiring and cut-outs checked by an electrician and repair if necessary.
R
ritareynoldsSep 13, 2025
How to fix a Tractel Chain Hoists when the motor starts but the rope doesn't move?
- A
  Alice CamposSep 14, 2025
  If the motor starts but the rope does not move on your Tractel Chain Hoists, it could be due to a rope jam in the hoist caused by a damaged or incorrect rope, or an obstructed rope exit. To resolve this: * Support the load (e.g., with a wedge clamp or lever hoist). * Cut the rope in front of and behind the hoist. * Send the hoist to be repaired. * When available, install a new rope in replacement hoist.

Tractel tirak X 300 P Series Specifications

General

Brand	Tractel
Model	tirak X 300 P Series
Category	Winches
Language	English

Summary

General Information and Safety

Terms, Abbreviations, and Symbols

Defines terms, abbreviations, and explains symbols used in the manual.

General Safety Instructions

Provides critical safety guidelines to prevent severe injuries and equipment damage.

Operator and System Responsibilities

Details operator responsibilities and safe working practices.

Product Overview and Technical Details

Product Overview, Description, and Specifications

Details delivery state, scope, description, function, and technical specifications.

Components, Safety Features, and Controls

Lists components, details safety features, and describes operating controls.

Installation and Commissioning

Directives, Standards, and Pre-Installation Checks

Lists compliance directives and outlines checks before starting installation.

Assembly, Wire Rope Mounting, and Commissioning

Provides instructions for assembly, wire rope mounting, commissioning, and functional tests.

Operation and Emergency Procedures

Pre-Operation Checks and Safe Operation

Details daily checks and safe operating practices, handling loads.

Emergency Procedures and Manual Operation

Steps after emergency stop, manual load lowering, and hand crank operation.

Maintenance, Adjustments, and Disposal

Shutting Down, Transport, and Storage

Procedures for shutting down, transporting, and storing the hoist.

Maintenance, Inspections, and Adjustments

Outlines maintenance tasks, inspections, and device adjustments.

Ordering Spare Parts and Disposal

Information on ordering parts and correct disposal of the equipment.

Troubleshooting and Limit Switches

Troubleshooting Common Faults

Provides solutions for common faults and operational problems encountered with the hoist.

Limit Switch Overview

Explains the function and types of limit switches used in the hoist system.

EU Declaration of Conformity

Related product manuals

Tractel tirak X 500 P Series

Tractel tirak X 820 P Series

Tractel tirak X 2050 P Series

Tractel tirak X 1030 P Series