What to do if my Trader Security Sensor will not operate at all?
If your Trader Security Sensor isn't working at all, first ensure that the power is switched ON at the circuit-breaker or internal wall switch. Also, check all connections to make sure they are secure and not loose.
Why is my Trader Security Sensor false triggering?
If your Trader Security Sensor is triggering falsely, it might be due to a few reasons. First, cover the sensor with a black cloth for 5 minutes to see if the light still triggers, as winds and drafts can sometimes activate it, especially in passages between buildings creating a 'wind tunnel' effect. Also, ensure the unit isn't detecting cars or people on public roads; if it is, adjust the sensitivity control to decrease the sensor's range or change the sensor head's direction.
What to do if Trader Security Sensor is not turning off?
If your Trader Security Sensor isn't turning off, it may be re-triggering. Stand outside the detection range and wait for the warm-up period to complete (it should not exceed 1 minute). Then, check for any heat or movement sources like animals, trees, or light globes within the detection area. Adjust the sensor head and controls as needed.
Why does my Trader Security Sensor activate during the daytime?
If your Trader Security Sensor activates during the daytime, it could be due to a low level of ambient light or the lux level control being set incorrectly. Try re-adjusting the lux control accordingly.
Why will my Trader Security Sensor PIR not operate at night?
If your Trader Security Sensor PIR will not operate at night, it may be due to too much ambient light. Adjust the lux level control accordingly and remove any other sources of ambient light.
How to make Trader Security Sensors operate during daylight?
If your Trader Security Sensor will not operate during daylight, the sensor might not be in daylight operation mode. To fix this, rotate the lux control fully clockwise.
Detailed step-by-step guide for physically installing the sensor unit.
Instructions on how to adjust the sensor head using locking nuts.
Details on how to enable permanent ON or AUTO mode for the sensor.
General| Brand | Trader |
|---|---|
| Model | ARCTIC OWL OWPIROD |
| Category | Security Sensors |
| Language | English |
To Next Page