Specications:
Detection method Optical
Power Supply Built-in DC3V Lithium battery (battery not replaceable)
Battery Lifetime 10 years
Monitored area 40 m²
Operating temperature 0 °C - 45 °C
Operating Humidity < 93 %
Date of replacement See product label
Individual alarm indicator Yes
Silence feature (hush mode) Yes | Hush time: 10±1 minutes
Low battery warning Yes
Low battery silence facility
installation in leisure
Yes | Hush time: 10 hours
Caravan and Motor Home Suitability No
Mounting Location Ceiling or wall
Inter-connectable Yes | max. 40 devices
Wireless frequency 433.42MHz
Wireless distance Max. 100 metres in free eld
Local smoke alarm sound pattern:
ISO 8201 BI 0.5s - pause 0.5s - BI 0.5s - pause 0.5s - BI 0.5s -
pause 1.5s, with the red LED ash, repeat this alarm pattern.
Wireless alarm sound pattern
Beep Beep - pause 1s, with the red LED ash, repeat this alarm
pattern.
Product function description:
Function Visual Indication Audio Indication
Normal Alarm Function
The Red LED ashes every 40
seconds.
None
Test (Button Pressed On Direct Unit)
• Test by pressing the TEST button on the smoke alarm
at least 5 seconds.
• The alarm will sound if all electronic circuitry, horn
and battery are working properly. If no alarm sounds,
refer to “Trouble Shooting”.
Flashes once per second for 3
seconds, pauses for 1.5 seconds
then cycles again.
Siren once per second for 3 seconds
then pause 1.5 seconds then cycle
again.
Test (Wireless Paired Unit)
Alarm being tested signals others in the network
Flash twice every 1 second for
duration of 5 minutes.
Beep twice for 10 seconds.
Local Alarm Detected Smoke
Flashes once per second for 3
seconds, pauses for 1.5 seconds
then cycles again.
Siren once per second for 3 seconds
then pause 1.5 seconds then cycle
again.
Paired Wireless Alarm None Continuous 2 beeps every 2 seconds.
Silence Feature (Hush Mode)
• This smoke alarm has a built-in Silence feature.
• If cooking or other non-hazardous sources cause
the alarm to sound, it can be temporarily silenced by
pressing the HUSH button for above 2 seconds.
• The alarm enters silence mode for 10 minutes. After
the 10 minute dormant period, the smoke alarm will
resume normal operation.
The Red LED ashes every 8
seconds.
None
Low Battery Warning
Need to replace for a new smoke alarm
The Red LED ashes every 40
seconds.
Beep every 40 seconds.
Connected Low Battery Warning
(Connected device battery is running low)
1 ash every 3 hours. 1 beep every 3 hours.
Low Battery Warning Silence Feature
(Low battery warning is muted)
None None
Internal Fault Warning
Need to replace smoke alarm
None Beep every 40 seconds.
Caution:
• Before using the silence function, identify the source of the smoke and ensure conditions are safe. The unit will resume
normal operation after 10 minute silence.
• DO not use an open ame to test your alarm, you could damage the alarm or ignite combustible materials and result in a re.
• Pull out the yellow tag insulation sheet in battery compartment before installing smoke alarm, or the smoke alarm won’t
work properly.
• If the alarm sounds, and it is not being tested, it means the unit detected smoke. THE SOUND OF THE ALARM REQUIRES
YOUR IMMEDIATE ATTENTION AND ACTION.
To Next Page
Need help?
General
