Traffic & Access Solutions Portaboom PB2000

Questions and Answers

J
Jason GravesAug 13, 2025
Why are the battery charge lights not illuminating on my Traffic & Access Solutions Control Systems?
- T
  tmorganAug 13, 2025
  If the battery charge lights are not illuminating on the Traffic & Access Solutions Control Systems control panel, first ensure the battery charger lead is securely connected to the rear of the 240V outlet located below the charger to the right. Next, check that the charging lead is securely connected to the 240V external outlet located to the left of the unit above the rear wheels. Also, verify that the charging lead is firmly connected to the power point and the power point is turned on. Finally, inspect the lead for any exposed wiring and ensure the lead's test and tag label is up to date; replace the lead if necessary.
K
kellyrossAug 17, 2025
How to troubleshoot a Traffic & Access Solutions Portaboom PB2000 Control Systems product / arm that is not operating?
- Z
  zleblancAug 17, 2025
  If the product or arm of your Traffic & Access Solutions Control Systems is not operating, start by opening the control panel and checking that all switch wiring is securely fastened to the PCB. If the fuse is blown, contact your distributor for a replacement. If the light is flashing red, charge the battery by connecting a charging lead to the 240V outlet (located bottom left of unit) to a 240V power point.
H
Haley MartinezAug 21, 2025
Why is the remote control distance too short for my Traffic & Access Solutions Portaboom PB2000?
- D
  Donald SparksAug 21, 2025
  If the remote control distance for your Traffic & Access Solutions Control Systems is too short, check that the antenna is securely tightened to the unit. If the issue persists, open the remote control casing and replace the battery with a new one of the same type.
A
Adam ZhangAug 25, 2025
What to do if the boom arm motion is not smooth on a Traffic & Access Solutions Control Systems?
- C
  Carla MoodyAug 26, 2025
  If the boom arm motion of your Traffic & Access Solutions Control Systems is not smooth, try tightening the spring located inside the casing. Also, ensure the billet locking nut is tightened.
B
Brian HarrisonAug 28, 2025
Why are the advisory LED’s unresponsive on my Traffic & Access Solutions Portaboom PB2000 Control Systems?
- S
  Shirley MorganAug 28, 2025
  If the advisory LEDs on your Traffic & Access Solutions Control Systems are unresponsive, check the wiring connection to the terminal block on the PCB, located at the back of the control panel. If the issue persists, consider replacing the LEDs; refer to your distributor for assistance.
J
Jenny EwingSep 1, 2025
What to do if the manual push button is unresponsive on a Traffic & Access Solutions Portaboom PB2000?
- T
  Tiffany BennettSep 1, 2025
  If the manual push button on your Traffic & Access Solutions Control Systems is unresponsive, open the control panel and check that the wiring is securely fastened to the PCB.
N
Nathan JohnsonSep 5, 2025
How to fix a bounce back function that is not working on a Traffic & Access Solutions Portaboom PB2000?
- B
  Brandon CastroSep 5, 2025
  If the bounce back function is not working on your Traffic & Access Solutions Control Systems, open the control panel and adjust the 'BLUE' amperage switch clockwise, located on the main PCB.
T
Tyler ParkerSep 8, 2025
What to do if stability legs won't slide on Traffic & Access Solutions Control Systems?
- A
  Adam ShermanSep 8, 2025
  Ensure the wing nut is wound back to nut.