Operating Instructions
The drill can loosen and cause injury.
3) If using a corded drill/driver, verify that the
power
on the Trailer Valet or moving vehicle will
not damage the cords or that the cords
cannot be stepped on, tripped over, or
otherwise subjected to damage or 4) Align
and insert the drill socket to the low gear
Step 7: RAISE THE STEERING HANDLE AND
ROTATE THE DRIVESHAFT
! WARNING Hold the drill/driver firmly
when engaging.
Re-Hitching Your Trailer
Step 1: CONNECT YOUR TRAILER TO THE
HITCH BALL
1)
the ground.
2) Remove any wheel
blocks below the trailer.
3) guide the trailer un l the
coupler is above the hitch ball of the towing
vehicle.
4) hitch ball, and lock the
coupler.
Step 2: REMOVE THE TRAILER
VALET 1) Remove the
drill/drive handle.
2)Lower the exis ng jack un l the Trailer Valet is
above ground.
To Next Page
Loading...