37
Following are the instructions for LP gas operation.
1. Open the valve at the gas storage tank.
2. Turn the thermostat to the 5 position.
3. Turn the selector switch to the propane gas position.
4. Push and hold in the safety valve and push in the igniter several
times in rapid succession, for about five seconds.
WARNING: Do not hold in the safety valve for more
than 30 seconds. If there is no flame in this time, wait
at least five minutes before you try ignition again.
5. When flame meter moves into the green area, release the safety
valve. If the flame meter does not move into the green area, do this
step again.
6. Turn the thermostat to the temperature setting that you wish.
Start up: AC operation:
Make sure that 120 volts AC is available.
Turn the selector switch to the AC position.
Turn the thermostat to the temperature setting desired.
Start up: DC operation:
Make sure that 12 volts DC is available.
Turn the selector switch to the DC position.
This refrigerator is made to operate on DC power while your vehicle is “in transit”
and AC power or propane gas sources are not available. Operate the
refrigerator on DC power
only when the vehicle engine is running.
For the refrigerator to operate correctly on DC power, the battery must be
maintained in a fully charged condition.
Additional information will be found in the refrigerator manufacturer
owner's manual.
To Next Page
Loading...
