How to fix Error 1 on Trainsway Industrial Equipment?
Error 1 indicates there is no signal to run, which stems from the position of the pickup board or the power supply board. If the shaft rotates, the pickup board needs replacement. However, if the shaft doesn’t rotate, the power supply board should be replaced.
What to do if Trainsway Industrial Equipment shows Error 8?
Error 8 indicates a problem with the pressure sensor or failure to add 100 gram lead during self-calibration. Run the self-calibration according to the instructions. If the problem continues, adjust the position of the pick-up print.
What to do if Trainsway ZH825B Industrial Equipment shows Error 2?
Error 2 means that the machine cannot detect the wheel. This can be caused by the wheel not being mounted properly or the belt being too tight. To resolve this, mount the wheel correctly or adjust the V-belt appropriately.
Why does my Trainsway Industrial Equipment show Error 3?
Error 3 occurs because the wheel isn't installed tightly enough or the pressure in the wheel is insufficient. To fix it, install the wheel tighter or ensure the correct pressure, as marked on the wheel, is applied.
How to resolve Error 4 on Trainsway Industrial Equipment?
Error 4 indicates a problem with the position of the pick up print. You should change the position of the pick up print or replace it.
What does Error 6 mean on Trainsway Industrial Equipment?
Error 6 indicates a problem with the supply board. The suggested solution is to replace the supply power board.
Guidelines for proper use and storage of the user manual for safe operation.
Essential safety rules and warnings for operating the tire balancing machine to prevent injury or damage.
Procedure for unpacking the machine and verifying all standard accessories are included.
Instructions for securely installing the threadspindle onto the machine's clamping shaft.
Steps for assembling the wheel cover, mounting it, and the final machine installation process.
Description of the digital displays and indicators on the wheel balancer control panel.
Explanation of DYN, STA, ALUS, ALU1, ALU2, and ALU3 modes for balancing various rim types.
Details on the function of each button on the control panel, including input and mode selection.
Instructions for using specific button combinations for functions like self-calibration and unit conversion.
Steps for preparing the wheel and mounting it using cones on the outside or inside.
How to measure and input rim width (b), diameter (d), and distance (a) for balancing.
Steps for placing weights on the rim based on indicator lights and confirming successful balancing.
Detailed steps for using ALUS mode and performing the self-calibration procedure.
Guide to adjusting display thresholds, sound, units, and other operational parameters.
Technical details including maximum wheel weight, power, accuracy, speed, and dimensions.
Overview of machine capabilities and required operating conditions for temperature, height, and humidity.
Table of problems, reasons, and solutions for common error codes encountered during operation.
Detailed list of machine components with numbers, descriptions, quantities, and fixed seats.
Official statement confirming the product's compliance with relevant EC directives and standards.
General| Brand | Trainsway |
|---|---|
| Model | ZH825B |
| Category | Industrial Equipment |
| Language | English |
To Next Page
