Air Filter Cover, Air Filter And Cylinder Cap
Motor Assembly
Jam Clear Lever Unit
Nose Piece
Contact Arm
Follower
Magazine Foot
Magazine Assembly
Follower Release
Lever
Battery
Low Battery Voltage Indicator Light
Handle Assembly
Actuator
Trigger
working direction, the adjustment of mains supply, the workpiece, the workpiece support.
NOTE: EXCEEDING THESE RATES COULD CAUSE THE TOOL TO OVERHEAT,
RESULTING IN LOSS OF PERFORMANCE OR DAMAGE TO TOOL COMPONENTS.
BY USING THE TRAK-IT TOOL AT ITS RECOMMENDED OPERATION RATE YOU WILL BE
ABLE TO DRIVE SEVERAL THOUSAND FASTENERS IN A TYPICAL WORKDAY.
Maximum Fastener Size:
1-1/2 inch (38 mm) long x. 102 inch (2.59 mm) diameter shank
Magazine Capacity:
Battery :
6 volts D.C. (nickel metal hydride) – Provides enough energy to drive approximately 3000
fasteners on a full charge.
Charge time – Approx. 2-1/2 hours.
Fuel Cell:
Liquid hydrocarbon – Provides enough fuel to drive up to 1200 fasteners.
(Dangerous goods class 2.1 UN1075 2.7 fl oz/40g/80ml)
NOTE: POWERS FASTENERS DECLARES THAT THE MODEL TI-C TOOL IS IN
CONFORMANCE WITH THE EUROPEAN "MACHINES" DIRECTIVE.
NOTE: The triangle symbol marked as " " following its tool serial number indicates that
safety yoke is equipped with this tool.
TRAK-IT C3
42 fasteners
TRAK-IT C3 ST
22 fasteners
To Next Page
Loading...