TrakPower TK955 User Manual

IRON HOLDER
TIP RETAINER NUT
CLEANING SPONGE
CHISEL TIP
TIP RETAINER
CALIBRATION ADJUSTMENT
SECURITY KEY
PENCIL TIP
TEMPERATURE CONTROLS
DIGITAL DISPLAY
RETAINING NUT
CORD
RECEPTACLE
™
For best results read the entire manual before operating.
TK955 Digital
Soldering Station
Packing List
● TK-955 Soldering Station ● Iron Holder with Sponge
● Soldering Iron with Tip ● 2 Security Keys
● Pencil Tip
Precautions
CAUTION: When the power is on, the tip temperature is between 200°C / 400°F and 480° C / 899°F. Since
mishandling may lead to burns or fi re, be sure to comply with the following precautions:
•
Do not touch the metallic parts while operating.
•
Always store the iron in the holder when not in use.
•
Do not use the product near fl ammable items.
•
Advise other people in the work area that the unit can reach a very high temperature and should be considered
potentially dangerous.
•
Turn the power off while taking breaks and when you are fi nished using it.
•
Before replacing parts or storing the unit, turn the power off and allow the unit to cool to room temperature.
To prevent damage to the unit and ensure a safe working environment, be sure to comply with the following precautions:
•
Do not use the unit for applications other than soldering.
•
Do not hit the soldering iron against the work bench or other objects to shake off residual solder.
•
Do not modify the unit.
•
Use only genuine replacement parts.
•
Do not bend or damage the security key. Should the key become bent, do not force it into the station.
•
Do not allow the unit to become wet or use the unit when your hands are wet.
•
The soldering process will produce smoke. Make sure the area is well ventilated.

TrakPower TK955 Specifications

General

Brand	TrakPower
Model	TK955
Category	Soldering Gun
Language	English

Summary

Precautions

Setup and Operation

Connecting and Powering On

Connect the soldering iron, install the tip, saturate the sponge, plug in the power cord, and turn on the switch.

Setting the Temperature

Temperature Adjustment Procedure

Use the security key and UP/DOWN buttons to adjust the 100's, 10's, and 1's digits of the temperature.

Parameter Adjustments

Entering Parameter Input Mode

Turn off power, hold UP/DOWN buttons, then turn on power to enter parameter input mode.

Changing Temperature Units

Use UP/DOWN buttons to switch between Celsius (1C) and Fahrenheit (1F) display units.

Setting Heater Error Tolerance

Adjust heater error temperature tolerance within specified ranges for °C or °F.

Room Temperature Compensation

Calibrate tip temperature by adjusting the 'CAL' screw to match room temperature.

Use

Soldering Best Practices

Select lowest required temperature, clean and tin tip, use minimal solder, and clean/tin after use.

Care

Soldering Iron Maintenance

Regularly clean tip, clean threads, avoid leaving unit on, keep sponge moist, and tin tip to reduce oxidation.

Replacing the Tip

Tip Replacement Steps

Cool iron, remove nut and holder, replace tip, clean threads, and install new tip finger tight.

Error Messages

System Error Explanation

Indicates an abnormality in system checks, stopping all operation.

Sensor Error Explanation

Indicates a possible failure in the sensor or circuit, cutting off power.

Heater Error Explanation

Flashing display indicates tip temperature falling below heater error tolerance.

Parts

Replacement Parts List

List of replacement parts including iron, sponge, and various tips.

Optional Parts List

List of optional items such as solder and cleaning wire.