5
ON/OFF
Press ON/OFF button
OPERATION lamp lights up or goes off and the sys-
tem starts or stops OPERATION.
For programming TEMPERATURE, FAN SPEED
and AIR FLOW DIRECTION, follow the procedure
shown below.
TEMPERATURE SETTING
Press TEMPERATURE SETTING button and
program the setting temperature.
Each time this button is pressed, setting
temperature rises 1°F.
Each time this button is pressed, setting
temperature lowers 1°F.
• The setting is impossible for fan operation.
NOTE
• The setting temperature range of the remote con-
troller is 60°F to 90°F.
FAN SPEED CONTROL
Press FAN SPEED CONTROL button.
High or Low fan speed can be selected.
The microchip may sometimes control the fan speed
in order to protect the unit.
AIR FLOW DIRECTION ADJUST
•
There are 2 ways of adjusting the air discharge angle.
A. UP AND DOWN DIRECTION
2
ADJUSTMENT
A. Up and down adjustment
B. Left and right direction
Press the AIR FLOW DIRECTION ADJUST but-
ton to select the air direction as shown below.
The AIR FLOW FLAP display
swings as shown below and the
air flow direction continuously
varies. (Automatic swing setting)
Press AIR FLOW DIRECTION
ADJUST button to select the air
direction of your choice.
The AIR FLOW FLAP display
stops swinging and the air flow
direction is fixed (Fixed air flow
direction setting).
MOVEMENT OF THE AIR FLOW FLAP
For the following conditions, micro computer con-
trols the air flow direction so it may be different from
the display.
We recommend using the fan in the position listed
above when fixing the fan direction.
B. LEFT AND RIGHT DIRECTION
Grasp the air flow blades at the tip and move the
blades to the left and right.
NOTE
• Only make adjustments after you have stopped
the air flow direction swing in a position where
adjustments are possible. Your hand may get
caught if you attempt to make adjustments while
the air flow flap is swinging.
Operation mode Cooling
Operation
condition
•
When room temperature is
lower than the set temperature
•
When operating continuously
at horizontal air flow direction
swing
Cooling
Recommended flap positions
02_EN_3VA13886-3A.fm Page 5 Friday, January 24, 2003 9:04 AM
To Next Page
Loading...
