Trans instruments BP3001 - CONFIGURING STABILITY INDICATOR; SETTING MEASUREMENT UNITS; SETTING THE REAL TIME CLOCK

8
Rdy (P6
P6P6
P6.0
00
0) STABILITY INDICATOR
This setting allows you to switch ON or OFF the stabilized reading
indicator. Whenever the READY sign appear on the top left corner of
the display, it indicates that a stable reading has reached. This will be
helpful to eliminate guesswork. In some case, especially where the
reading is very slow in response, switch OFF the indicator for
independent user’s judgment. Factory preset is ON.
1. Press and display will show yES
yESyES
yES (P6
P6P6
P6.1) with flashing.
2. Press to select between yES
yESyES
yES or no
nono
no
3. Set to no
nono
no and press to disable endpoint indicator, display
will return to Rdy
RdyRdy
Rdy (P6
P6P6
P6.0
00
0)
4. Press to go to next parameter.
Un it (P7
P7P7
P7.0
00
0) UNIT OF MEASUREMENT
This setting allows you to set the unit of measurement for temperature.
Factory preset is in °C.
1. Press and display will show Unit
UnitUnit
Unit (P7
P7P7
P7.1
11
1) with C
CC
C flashing.
2. Press to change between F
FF
For C
CC
C.
3. Press to confirm setting, display will return to Unit
UnitUnit
Unit (P7
P7P7
P7.0
00
0).
4. Press to go to next parameter.
Rtc (P8
P8P8
P8.0
00
0) REAL TIME CLOCK
This setting allow you to change the date in Year-Month-Date and time
in Hour:Minute:Second on the unit.
1. Press and display will show rtc
rtcrtc
rtc (P8
P8P8
P8.1
11
1) with 2 digit flashing
below Y-year.
2. Press or to change the value of Year.
3. Press to confirm, display will show rtc
rtcrtc
rtc (P8
P8P8
P8.2
22
2) with the next
2-digit flashing below M-month.
4. Repeat step 2 to 3 to change each setting in the following sequence
of Day(P8
P8P8
P8.3
33
3), Hour(P8
P8P8
P8.4
44
4), Minute(P8
P8P8
P8.5
55
5) and Second(P8
P8P8
P8.6
66
6).
5. After confirming the last setting, display will return to rtc
rtcrtc
rtc (P8
P8P8
P8.0
00
0)
6. Press to go to next parameter.