Transcend DrivePro 620 - 3-3 Parking Mode Recording

3-3 Parking Mode Recording
After the car engine is switched o ff , the DrivePro can automatically enter Parking mode and record
footage when motion or collision is detected. Parking mode is disabled by default and can be enabled in
Settings menu.
During Parking mode, the LCD display will turn o ff and the LED indicator will remain solid red on standby.
When a motion or collision of the vehicle is detected, the DrivePro will record footage of about 15
seconds; the display will turn on and the LED will fl ash red. The display will turn o ff again if no more
motion/collision is detected in about 15 seconds. The DrivePro will resume Normal Recording mode
when the engine is switched on again (connected to power).
Transcend ’ s power cable does not supply power after the engine is switched o ff . If long-term recording in
Parking mode is required, please use an external power supply. Enter the Parking mode manually by
long-pressing the Power button in Normal Recording mode. To power o ff the DrivePro, long-press
the Power button again.
"Note"
Loop recording is enabled by default, so the DrivePro will automatically overwrite the earliest
emergency fi les with the latest ones recorded.

"Note"
After switching o ff the car engine, enabling Parking mode may drain the DrivePro ’ s built-in battery.
