Transcend DrivePro Body 20 User Manual

19
When there are fingerprints on the lens surface
When the lens is exposed to salty air such as at the seaside
 Store in a well-ventilated location subject to little dirt or dust
 To prevent mold, periodically clean the lens as described above
Cleaning
Clean the DrivePro™ Body 20 surface with a soft cloth slightly moistened with water, then wipe the
surface with a dry cloth. Do not use any of the following as they may damage the finish or the casing:
 Chemical products such as thinner, benzine, alcohol, disposable cloths, insect repellent,
sunscreen or insecticide, etc.
 Do not touch the camera with any of the above on your hand.
 Do not leave the camera in contact with rubber or vinyl for a long time.
Moisture condensation
 If the DrivePro™ Body 20 is brought directly from a cold to a warm place (or vice versa),
moisture may condense inside or outside the camera. This moisture condensation may cause
malfunction of the DrivePro™ Body 20.
 If moisture condensation occurs, turn off the DrivePro™ Body 20 and wait about 1 hour for the
moisture to evaporate.
Bundled Velcro usage
 The bundled Velcro is recommended for raincoats, windcheaters and other plastic surfaces, but
not recommended for cotton, wool or leather. If you want to use it on such fabrics, please sew it
on.
 Each set of Velcro has two sides. Please adhere one side to the bundled Velcro holder and the
other side to another surface.
 Application instructions: Clean and dry surface before application. Peel tape and press firmly
into place. Leave for 24 hours for best performance.
10. IPX4 Water Resistant
The camera body of the DrivePro™ Body 20 is IPX4 water resistant (not waterproof), offering
protection against splashing water from any direction. However, it is not protected against
pressurized water such as from a shower or tap.
WARNING: DrivePro™ Body 20 is not water resistant when connected to the power
cable.
Failure caused from incorrect use is not covered by the limited warranty.
 Do not use the DrivePro™ Body 20 in water as it is not waterproof.

Transcend DrivePro Body 20 Specifications

General

Frame Rate	30 fps
Microphone	Built-in
Speaker	Built-in
USB Connection	USB 2.0
Video Resolutions	1920 x 1080, 1280 x 720
Waterproof	IPX4
Video Resolution	1920x1080 (Full HD)
Storage Capacity	Supports microSD cards up to 128GB
Connectivity	Wi-Fi
Storage	microSD card
Display	1.5" LCD
Image Sensor	CMOS
Video Format	H.264
Battery	Rechargeable Li-ion
Mounting	Clip