Transition RELAY - System Power and Battery Status; Powering the System ON and OFF; State of Charge Indicator; Battery Charging and Support Modes

Transition Bicycle Company™ 2023 | transitionbikes.com | (360) 366-4960 | info@transitionbikes.com
QUICK START GUIDE:
Powering the System ON and OFF
Charging Your Battery
1. To turn on your bike, press and hold the Ring-
Controller in the up position for 2 secs.
2. To turn off your bike, press and hold the Ring-
Controller in the down position for 2 secs.
Note: The battery does NOT come fully charged and
must be completely charged before riding. The Relay
battery must be removed from the bike in order to
charge it.
1. Remove the battery from the bike.
2. Plug the battery charger cord into a standard outlet.
3. Plug the power cable into the port on the back side
of the battery.
The LED on the charger will light up RED when the
battery is initially plugged in. When the battery is fully
charged the LED will change to green to indicate the
battery is fully charged.
ON OFF
Tip: Once the system has been turned on, the lights on the LED hub will illuminate to indicate the charge level.
1 LED = 0-20%, 2 LEDs = 20-40%, 3 LEDs = 40-60%, 4 LEDs = 60-80%, 5 LEDs = 80-100%
Switching Support Modes
• To increase the support level, push the ring controller
up once.
• To decrease the support level, push the ring controller
down once.
Tip: The LED Hub will indicate the current support level.
Switching Support Modes
1. 2.
3.a
3.b
1. 2.